MOTOR OMR X 100CC 6 SPLINE SAE 6B
Hydrokit Part Number : MHR100ACAX
Technical information
Danfoss OMR X semi-rapid motor
Danfoss reference: 11185588
Capacity: 100 cc
SAEA 2-hole flange - centering 82.5 mm
Fluted shaft 6 teeth diameter 1 inch
Offset side holes Ø G 1/2
Drain size: G 1/4
Standard dust cover gasket
Maximum pressure on the shaft seal = 225 bar
Front bearing = Fluid bearing
Rear bearing = Fluid bearing
Integrated drainage valves
Danfoss reference: 11185588
Capacity: 100 cc
SAEA 2-hole flange - centering 82.5 mm
Fluted shaft 6 teeth diameter 1 inch
Offset side holes Ø G 1/2
Drain size: G 1/4
Standard dust cover gasket
Maximum pressure on the shaft seal = 225 bar
Front bearing = Fluid bearing
Rear bearing = Fluid bearing
Integrated drainage valves
Technical data
| Motor type | OMR Geroller |  |
|
| Displacement | 100 | cc/rev | |
| Flange type | SAE A flange |  |
|
| Shaft type | Splined |  |
|
| Size of the shaft | 1 inche | ||
| Orifices position | Side port - Offset |  |
|
| Orifices A & B size | 1/2 BSPP | ||
| Taille du drain | 1/4 BSPP | ||
| Shaft seal | Int. in shaft seal 225 bar | ||
| Bearing type | Journal bearing | ||
| Speed sensor | No | ||
| Paint | Not paint | ||
| Marque | Danfoss |  |